LTC Timecode Listener
Loading…
Connecting…
Enter the event code you were given:
◐ Frame rate
◷ Time code offset
:
:
;
HH : MM : SS ; FF
✎ Timecode adjust
+0 f
(+0 ms)
Slide to shift the LTC output by up to ±60 frames (≈ ±2.4 s at 25 fps). Use this to compensate for cable / device latency to your hardware LTC reader.
Frame rate
—
Time code offset
—
Timecode adjust
+0 f (+0 ms)
Hardware reader setup
Connect this device to your LTC reader via the headphone jack (or a USB-C → 3.5 mm adapter). Set your device volume to 75–100 % and verify the reader shows a lock indication. The signal is mono, full-scale, biphase-mark encoded.
Connect this device to your LTC reader via the headphone jack (or a USB-C → 3.5 mm adapter). Set your device volume to 75–100 % and verify the reader shows a lock indication. The signal is mono, full-scale, biphase-mark encoded.
Frame rate
—
Time code offset
—
Timecode adjust
+0 f (+0 ms)
Show starts in:
--:--
00:00:00;00
—
TC offset —
idle
✎ Timecode adjust
+0 f
(+0 ms)
Show ended.
LTC output stopped.